SNJ54ALS561AJ
| Parameters | |
|---|---|
| Package / Case | CDIP |
| Surface Mount | NO |
| Pbfree Code | no |
| Number of Terminations | 20 |
| Additional Feature | TCO OUTPUT; COUNT ENABLE INPUTS |
| HTS Code | 8542.39.00.01 |
| Subcategory | Counters |
| Technology | TTL |
| Terminal Position | DUAL |
| Terminal Form | THROUGH-HOLE |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 2.54mm |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Pin Count | 20 |
| JESD-30 Code | R-GDIP-T20 |
| Qualification Status | Not Qualified |
| Operating Temperature (Max) | 125°C |
| Operating Temperature (Min) | -55°C |
| Supply Voltage-Max (Vsup) | 5.5V |
| Power Supplies | 5V |
| Temperature Grade | MILITARY |
| Supply Voltage-Min (Vsup) | 4.5V |
| Load Capacitance | 50pF |
| Number of Bits | 4 |
| Family | ALS |
| Output Characteristics | 3-STATE |
| Logic IC Type | BINARY COUNTER |
| Screening Level | MIL-PRF-38535 |
| Trigger Type | POSITIVE EDGE |
| Propagation Delay (tpd) | 21 ns |
| Power Supply Current-Max (ICC) | 33mA |
| fmax-Min | 25 MHz |
| Count Direction | UP |
| Load/Preset Input | YES |
| Mode of Operation | SYNCHRONOUS |
| Height Seated (Max) | 5.08mm |
| Length | 24.195mm |
| Width | 7.62mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
SNJ54ALS561AJ Overview
This is a device supplied in the CDIP package. This configuration uses 20terminations. 5Vis enabled to operate in an extremely flexible manner due to its supply voltage. A total of 20pins are present on all components. Initially, it appears to belong to the ALS family. In the device, the information consists of 4 bits. The result may be nowhen expressing the result in Pbfree code. It is important to note that in regards to this electronic device, TCO OUTPUT; COUNT ENABLE INPUTSis an extremely significant feature. The device is manufactured at MILITARYdegrees Celsius. From the voltage source, there is 5Vvoltage. There is a minimum supply voltage (Vsup) of 4.5V volts. It is possible to supply voltages up to 5.5V volts (Vsup). This electronic component is from the Counters family. A logic IC with the type BINARY COUNTERis used. In general, the maximum operating temperature is set to 125°C. As a general rule, the minimum operating temperature is set to -55°C.
SNJ54ALS561AJ Features
Embedded in the CDIP package
TCO OUTPUT; COUNT ENABLE INPUTS
BINARY COUNTER as logic IC type
SNJ54ALS561AJ Applications
There are a lot of Texas Instruments SNJ54ALS561AJ Counters & Dividers applications.
- Timing applications
- Frequency division
- Control counters
- counting/frequency sy nthesizers-BCD output
- Binary counter/decoder
- Time-delay circuits
- Fixed and programmable counters greater than 10
- Programmable binary and decade
- Frequency dividing circuits
- Frequency dividers