SN74F299N3
| Parameters | |
|---|---|
| Package / Case | PDIP |
| Surface Mount | NO |
| Number of Pins | 20 |
| Pbfree Code | no |
| Number of Terminations | 20 |
| HTS Code | 8542.39.00.01 |
| Subcategory | Shift Registers |
| Technology | TTL |
| Terminal Position | DUAL |
| Terminal Form | THROUGH-HOLE |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 2.54mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Pin Count | 20 |
| Qualification Status | Not Qualified |
| Operating Temperature (Max) | 70°C |
| Supply Voltage-Max (Vsup) | 5.5V |
| Power Supplies | 5V |
| Temperature Grade | COMMERCIAL |
| Supply Voltage-Min (Vsup) | 4.5V |
| Number of Bits | 8 |
| Family | F/FAST |
| Output Characteristics | 3-STATE |
| Output Polarity | TRUE |
| Logic IC Type | PARALLEL IN PARALLEL OUT |
| Trigger Type | POSITIVE EDGE |
| Propagation Delay (tpd) | 12 ns |
| fmax-Min | 70 MHz |
| Count Direction | BIDIRECTIONAL |
| Max Frequency@Nom-Sup | 70000000Hz |
| Height Seated (Max) | 5.08mm |
| Length | 25.4mm |
| Width | 7.62mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
SN74F299N3 Overview
PDIP is a package containing the embedded device. A total of 20 terminations can be found on the chip. 5V is the operating supply voltage of the part. It is equipped with a pin count of 20. An electronic component is included in the F/FAST. There must be a minimum supply voltage (Vsup) of 4.5V for this part. It can deliver voltage at 5V. Vsup cannot exceed 5.5V for this part. It has a total of 8 pins. The total number of pins is 20. There is a subcategory of it called Shift Registers. You should not use it above 70°C.
SN74F299N3 Features
With 20 pins
It supplies 5V power
SN74F299N3 Applications
There are a lot of Texas Instruments SN74F299N3 Shift Registers applications.
- Sequence generator
- Remote control holding register
- Counter
- LED matrix control
- data manipulation
- Flash Memory
- Remote control holding register
- 7-segment display control
- Data Format Converters
- Serial-to-parallel data conversion