SN74AHC174DG4
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | SOIC |
| Number of Pins | 16 |
| Weight | 141.690917mg |
| JESD-609 Code | e4 |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 16 |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | FF/Latches |
| Packing Method | TUBE |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 3.3V |
| Frequency | 180MHz |
| Pin Count | 16 |
| Number of Elements | 1 |
| Polarity | Non-Inverting |
| Temperature Grade | INDUSTRIAL |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 2V |
| Load Capacitance | 50pF |
| Current - Output | 8mA |
| Propagation Delay | 14.5 ns |
| Turn On Delay Time | 1 ns |
| Family | AHC/VHC/H/U/V |
| Logic Function | D-Type |
| Output Characteristics | 3-STATE |
| Logic IC Type | D FLIP-FLOP |
| Max I(ol) | 0.008 A |
| Number of Bits per Element | 6 |
| High Level Output Current | -8mA |
| Low Level Output Current | 8mA |
| Clock Edge Trigger Type | Positive Edge |
| Height | 1.58mm |
| Length | 9.9mm |
| Width | 3.91mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
SN74AHC174DG4 Overview
As a result, it is packaged as SOIC. The element count is 1 . In 16terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. It is powered by a voltage of 3.3V . A device of this type belongs to the family of AHC/VHC/H/U/V. Surface Mount mounts this electronic component. The 16pins are designed into the board. Its clock edge trigger type is Positive Edge. This RS flip flops is a part number FF/Latches. In view of its reliability, this D flip flop is a good fit for TUBE. In this case, the high level output current is set to -8mA. Low level output current is set to 8mA. A temperature below 85°Cis recommended for operation. Temperatures above -40°Cshould be used. It operates with the minimal supply voltage of 2V. 5.5Vis its maximum supply voltage. This can be achieved at a frequency of 180MHz. D FLIP-FLOPis used as the logic IC in this D flip flop. It is equipped with 1 functions . A total of 16 pins are present on this device. As a result of its output current of 8mA, it is very flexible in terms of design.
SN74AHC174DG4 Features
16 pins
1 Functions
16 pin count
SN74AHC174DG4 Applications
There are a lot of Texas Instruments SN74AHC174DG4 Flip Flops applications.
- Guaranteed simultaneous switching noise level
- Latch-up performance
- Frequency Dividers
- Count Modes
- Circuit Design
- Data storage
- Balanced 24 mA output drivers
- Synchronous counter
- Balanced Propagation Delays
- Latch