SN5490AJ
| Parameters | |
|---|---|
| Package / Case | CDIP |
| Surface Mount | NO |
| Pbfree Code | no |
| Number of Terminations | 14 |
| Additional Feature | ONE FUNCTION HAS 1 BIT |
| HTS Code | 8542.39.00.01 |
| Technology | TTL |
| Terminal Position | DUAL |
| Terminal Form | THROUGH-HOLE |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 2 |
| Supply Voltage | 5V |
| Terminal Pitch | 2.54mm |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Pin Count | 14 |
| JESD-30 Code | R-GDIP-T14 |
| Qualification Status | Not Qualified |
| Operating Temperature (Max) | 125°C |
| Operating Temperature (Min) | -55°C |
| Supply Voltage-Max (Vsup) | 5.5V |
| Power Supplies | 5V |
| Temperature Grade | MILITARY |
| Supply Voltage-Min (Vsup) | 4.5V |
| Load Capacitance | 15pF |
| Number of Bits | 3 |
| Family | TTL/H/L |
| Logic Function | Counter |
| Max I(ol) | 0.016 A |
| Trigger Type | NEGATIVE EDGE |
| Propagation Delay (tpd) | 50 ns |
| Power Supply Current-Max (ICC) | 42mA |
| fmax-Min | 32 MHz |
| Count Direction | UP |
| Max Frequency@Nom-Sup | 16000000Hz |
| Load/Preset Input | YES |
| Mode of Operation | ASYNCHRONOUS |
| Height Seated (Max) | 5.08mm |
| Length | 19.56mm |
| Width | 7.62mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
SN5490AJ Overview
This device is supplied in the CDIP package. In order to configure it, it uses 14terminations. With a supply voltage of 5V volts, it is possible to run it in a fully flexible manner. In total, there are 14pins on the component. In this case, it belongs to the family of [0]. There are 3bits of information contained in the device. Pbfree code may produce the result no. In regard to this electronic device, ONE FUNCTION HAS 1 BITare essential features. In this device, the temperature grade is MILITARY. Voltage from the voltage source is [0]. Supply voltage (Vsup) can be as low as 4.5V. Up to 5.5Vis the maximum supply voltage (Vsup). Typically, the maximum operating temperature is set to 125°C. It is generally recommended that the minimum operating temperature be set at -55°C.
SN5490AJ Features
Embedded in the CDIP package
ONE FUNCTION HAS 1 BIT
SN5490AJ Applications
There are a lot of Texas Instruments SN5490AJ Counters & Dividers applications.
- counting/frequency sy nthesizers-BCD output
- Up Counters
- SQUARING
- VHF, UHF, FM, AM, etc.
- TRUE RMS-TO-DC CONVERSION
- Fixed or Programmable Frequency Division
- LINEARIZATION
- Communications Digital Frequency Synthesizers;
- Signal gating
- Clocks