SIP4282ADVP3-T1GE3
| Parameters | |
|---|---|
| Factory Lead Time | 14 Weeks |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | PowerPAK® SC-75-6L |
| Number of Pins | 6 |
| Weight | 95.991485mg |
| Operating Temperature | -40°C~125°C TJ |
| Packaging | Tape & Reel (TR) |
| Published | 2013 |
| Feature | Load Discharge, Slew Rate Controlled |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| ECCN Code | EAR99 |
| Resistance | 520mOhm |
| Terminal Finish | Pure Matte Tin (Sn) |
| Subcategory | Peripheral Drivers |
| Max Power Dissipation | 610mW |
| Technology | MOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 260 |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 6 |
| Number of Outputs | 1 |
| Output Type | P-Channel |
| Max Output Current | 1.4A |
| Power Supplies | 2/5V |
| Interface | On/Off |
| Output Configuration | High Side |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Input Type | Non-Inverting |
| Turn On Delay Time | 20 μs |
| Switch Type | General Purpose |
| Turn-Off Delay Time | 4 μs |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 1.5V~5.5V |
| Driver Number of Bits | 1 |
| Rds On (Typ) | 350m Ω |
| Output Current Flow Direction | SOURCE |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
SIP4282ADVP3-T1GE3 Overview
It is packaged in the manner of a Tape & Reel (TR).It's included in the PowerPAK? SC-75-6L package.The mounting type of the LED driver is Surface Mount.General Purpose is the switch type that it owns.It is recommended that the temperature be set to -40°C~125°C TJ for reliable operation.As a default, the output is set to 1.The LED driving board is powered by a voltage of Not Required.A maximum output voltage of P-Channel volts has been specified.Load Discharge, Slew Rate Controlled features are available on the lighting driver.In total, there are 6 terminations.The operation is carried out using the 6 pins.To comply with the operation criteria, the maximum output current is reduced to 1.4A.Surface Mount is mounted in the way of this lighting driver.A total of 6 pins are included in this LED driver.520mOhm resistance is present in the lighting driver.The LED driver is packaged in an econtainer with a capacity of Peripheral Drivers.This part's power supply is 2/5V.
SIP4282ADVP3-T1GE3 Features
Resistance of 520mOhm
SIP4282ADVP3-T1GE3 Applications
There are a lot of Vishay Siliconix SIP4282ADVP3-T1GE3 Power Switches ICs applications.
- Solid-State Drives
- Portable GPS
- USB Protection
- Storage (HDDs, SSDs)
- Wearable Devices
- Hot Swap
- USB Power Distribution
- PDAs
- Smart Phones, Feature Phones
- Low Voltage I/O System Power