MPC17529EJR2
| Parameters | |
|---|---|
| Factory Lead Time | 14 Weeks |
| Mounting Type | Surface Mount |
| Package / Case | 20-TSSOP (0.173, 4.40mm Width) Exposed Pad |
| Surface Mount | YES |
| Operating Temperature | -20°C~150°C TJ |
| Packaging | Tape & Reel (TR) |
| Published | 2013 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 20 |
| ECCN Code | EAR99 |
| Applications | Battery Powered |
| HTS Code | 8542.39.00.01 |
| Subcategory | Motion Control Electronics |
| Technology | CMOS |
| Voltage - Supply | 2.7V~5.6V |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Supply Voltage | 5V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| JESD-30 Code | R-PDSO-G20 |
| Function | Driver - Fully Integrated, Control and Power Stage |
| Qualification Status | Not Qualified |
| Supply Voltage-Max (Vsup) | 5.6V |
| Power Supplies | 5V |
| Supply Voltage-Min (Vsup) | 2.7V |
| Interface | Parallel |
| Analog IC - Other Type | STEPPER MOTOR CONTROLLER |
| Output Configuration | Half Bridge (4) |
| Current - Output | 700mA |
| Supply Current-Max (Isup) | 3mA |
| Voltage - Load | 2V~6.8V |
| Motor Type - AC, DC | Brushed DC |
| Motor Type - Stepper | Bipolar |
| Height Seated (Max) | 1.1mm |
| Length | 6.5mm |
| Width | 4.4mm |
| RoHS Status | ROHS3 Compliant |
MPC17529EJR2 Overview
Drivers controllers is designed wDrivers controllersh a package of [0].Drivers controllers is packaged wDrivers controllersh a 20-TSSOP (0.173, 4.40mm Width) Exposed Pad case.Ideally, the part should be mounted by Surface Mount.The component connected in Battery Poweredis compatible with it.2.7V~5.6V volts can be supplied by the device.The operating temperature ranges from -20°C~150°C TJto -20°C~150°C TJ.A Brushed DCmotor can be classified as a type of motor.This part provides 20terminations.If the voltage is applied to the load at the rate of [0], the load will be affected.Drivers controllers is important to note that this amplifier should be operated at the 5Vsetting.Maintain a current of 700mAfor the part output.In this device, the analog IC STEPPER MOTOR CONTROLLERis employed.This is part of the Motion Control Electronics series.
MPC17529EJR2 Features
Applications : Battery Powered
Load voltage across the chip 2V~6.8V
MPC17529EJR2 Applications
There are a lot of NXP USA Inc. MPC17529EJR2 motor drivers applications.
- AM radio
- LED bias
- Human-centric lighting
- Dome
- Monitoring the energy that the luminaire uses
- Brake lights
- Emergency lighting
- A cross between entertainment
- Horticultural lighting
- Step-up or step-down driver topologies