MAX4711EPE
| Parameters | |
|---|---|
| Mounting Type | Through Hole |
| Package / Case | 16-DIP (0.300, 7.62mm) |
| Surface Mount | NO |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 2004 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 25Ohm |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Additional Feature | CAN ALSO OPERATE FROM SINGLE SUPPLY OF 2.7V TO 11V |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 4 |
| Supply Voltage | 5V |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Base Part Number | MAX4711 |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| JESD-30 Code | R-PDIP-T16 |
| Qualification Status | Not Qualified |
| Power Supplies | 3/5/+-5V |
| Number of Channels | 1 |
| Number of Circuits | 4 |
| Voltage - Supply, Single/Dual (±) | 2.7V~11V ±2.7V~5.5V |
| Neg Supply Voltage-Nom (Vsup) | -5V |
| On-State Resistance (Max) | 25Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 59 dB |
| Current - Leakage (IS(off)) (Max) | 500pA |
| Channel Capacitance (CS(off), CD(off)) | 8pF 8pF |
| On-state Resistance Match-Nom | 0.2Ohm |
| Switch Circuit | SPST - NC |
| Switch Time (Ton, Toff) (Max) | 125ns, 80ns |
| Charge Injection | 25pC |
| Channel-to-Channel Matching (ΔRon) | 200m Ω |
| Crosstalk | -87dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 125ns |
| Switch-off Time-Max | 80ns |
| Normal Position | NC |
| Length | 19.175mm |
| Width | 7.62mm |
| RoHS Status | Non-RoHS Compliant |
MAX4711EPE Overview
Packed in 16-DIP (0.300, 7.62mm), the electronic component is convenient for shipping overseas. Advanced packaging method Tube is used to provide high reliability. The multiplexer is located in Through Hole. 1:1 is the number of circuits in the multiplexer and demultiplexer. An extended operating temperature of -40°C~85°C TA degrees Celsius. There are 16 terminations totally. The electronic part delivers high-quality output through its 1 channels. With a 5V voltage supply, the electrical component should be turned on and run. There is an electrical component included in the 16 series. Multiplexers built on a SPST - NC switching circuit are built. There are 4 circuits in this multiplexer. Try searching for MAX4711 variants of the analog switch ic. There is 25Ohm internal resistance in this digital multiplexer. Multiplexer or Switches is a typical switch device. There are SEPARATE OUTPUT outputs on this analog switch ic. Don't forget the additional features of this electronic part, such as: CAN ALSO OPERATE FROM SINGLE SUPPLY OF 2.7V TO 11V.
MAX4711EPE Features
1 Channels
Switch Circuit: SPST - NC
Additional Features: CAN ALSO OPERATE FROM SINGLE SUPPLY OF 2.7V TO 11V
MAX4711EPE Applications
There are a lot of Maxim Integrated MAX4711EPE Analog Switches & Multiplexers ICs applications.
- Audio signal routing
- High speed data transmission line cards
- Existing multiplexer applications (both fault-protected and nonfault-protected)
- Data switching
- Microwave transmission systems
- Access Concentrators
- Microprocessor controlled systems
- FTTH
- Mechanical reed relay replacement
- Battery Powered Systems