MAX4643ETA+T
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-WDFN Exposed Pad |
| Number of Pins | 8 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2002 |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Resistance | 4Ohm |
| Max Power Dissipation | 362mW |
| Base Part Number | MAX4643 |
| Number of Circuits | 2 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.8V |
| Operating Supply Current | 1nA |
| Nominal Supply Current | 1μA |
| Throw Configuration | SPST |
| Turn On Delay Time | 10 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 20 ns |
| On-State Resistance (Max) | 4Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Current - Leakage (IS(off)) (Max) | 250pA |
| Channel Capacitance (CS(off), CD(off)) | 7pF 7pF |
| Switch Circuit | SPST - NO/NC |
| Switch Time (Ton, Toff) (Max) | 15ns, 8ns |
| Charge Injection | 2pC |
| Channel-to-Channel Matching (ΔRon) | 200m Ω |
| Crosstalk | -97dB @ 1MHz |
| Voltage - Supply, Single (V+) | 1.8V~5.5V |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
MAX4643ETA+T Overview
Presented in 8-WDFN Exposed Pad, this electrical component is convenient for overseas shipping. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). Mounted in Surface Mount is this multiplexer. Multiplexers and demultiplexers have a number of circuits 1:1. Temperatures around -40°C~85°C TA are extended for operation. Unlike digital switches, these are based on SPST - NO/NC switching circuits. There are 2 circuits in this multiplexer. MAX4643 can be used to search for analog multiplexer variants. The internal resistance of this digital multiplexer is 4Ohm. The datasheets for the 8 pins explain the functions. normally, users should not supply switches with voltages higher than 5.5V. Analog switch ics with Single supply type are cost-effective. 1.8V is the lowest voltage that should be fed to the electronic electronic part. This multiplexer would work with 1nA current. A voltage of 1.8V~5.5V is required to drain this analog switch from a single voltage supply.
MAX4643ETA+T Features
Switch Circuit: SPST - NO/NC
1nA Supply Current
MAX4643ETA+T Applications
There are a lot of Maxim Integrated MAX4643ETA+T Analog Switches & Multiplexers ICs applications.
- Sample hold systems
- Mechanical reed relay replacement
- Existing multiplexer applications (both fault-protected and nonfault-protected)
- Wireless Local Loop
- Audio and video signal routing
- Video signal routing
- Frame Relay Equipment
- Remote Powered Equipment
- Medical systems
- DSUs