MAX389CPN
| Parameters | |
|---|---|
| Mounting Type | Through Hole |
| Package / Case | 18-DIP (0.300, 7.62mm) |
| Surface Mount | NO |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tube |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 18 |
| Terminal Finish | TIN LEAD |
| Additional Feature | FAULT PROTECTED; OVERVOLTAGE PROTECTION |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 245 |
| Number of Functions | 1 |
| Supply Voltage | 15V |
| Reach Compliance Code | unknown |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Pin Count | 18 |
| JESD-30 Code | R-PDIP-T18 |
| Number of Channels | 4 |
| Number of Circuits | 2 |
| Analog IC - Other Type | DIFFERENTIAL MULTIPLEXER |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| On-State Resistance (Max) | 3kOhm |
| Multiplexer/Demultiplexer Circuit | 4:1 |
| Off-state Isolation-Nom | 68 dB |
| Current - Leakage (IS(off)) (Max) | 500pA |
| Channel Capacitance (CS(off), CD(off)) | 5pF 25pF |
| On-state Resistance Match-Nom | 300Ohm |
| Switch Circuit | SP4T |
| Switch Time (Ton, Toff) (Max) | 1.5μs, 1μs |
| Charge Injection | 55pC |
| Channel-to-Channel Matching (ΔRon) | 300 Ω |
| Switch-on Time-Max | 1ns |
| Switch-off Time-Max | 1ns |
| Voltage - Supply, Dual (V±) | ±4.5V~18V |
| RoHS Status | Non-RoHS Compliant |
MAX389CPN Overview
The electronic part can be shipped overseas conveniently because it is packaged in 18-DIP (0.300, 7.62mm). The advanced packaging method Tube provides high reliability. In Through Hole, you'll find this switch device. 4:1 is the ratio between multiplexers and demultiplexers. Increasing operating temperature to around 0°C~70°C TA. A total of 18 terminations have been recorded. This electronic part offers high-quality output due to its 4 channels. A 15V voltage supply should turn on and run the electronic component. Into the electrical component body are injected 18 pins. A SP4T switching circuit is used to build these analog multiplexers. It consists of 2 circuits. There is an integrated analog IC DIFFERENTIAL MULTIPLEXER in the module. Check out the electrical component's additional features, such as the following: FAULT PROTECTED; OVERVOLTAGE PROTECTION.
MAX389CPN Features
4 Channels
Switch Circuit: SP4T
Additional Features: FAULT PROTECTED; OVERVOLTAGE PROTECTION
MAX389CPN Applications
There are a lot of Rochester Electronics, LLC MAX389CPN Analog Switches & Multiplexers ICs applications.
- Routers
- Signal routing between systems
- Audio signal routing
- High reliability control systems
- Video switching
- Access Concentrators
- Multi-Line E1 Interface Cards
- Communication systems
- Fiber In The Loop (FITL)
- Relay Replacement