MAX14762ETB+T
| Parameters | |
|---|---|
| Factory Lead Time | 6 Weeks |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 10-WFDFN Exposed Pad |
| Number of Pins | 10 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2012 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 10 |
| Resistance | 20Ohm |
| Subcategory | Multiplexer or Switches |
| Technology | BICMOS |
| Terminal Position | DUAL |
| Number of Functions | 2 |
| Terminal Pitch | 0.5mm |
| Base Part Number | MAX14762 |
| Output | SEPARATE OUTPUT |
| Power Supplies | 3.3/5V |
| Number of Circuits | 2 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 3V |
| Operating Supply Current | 4.1mA |
| Throw Configuration | SPST |
| Supply Type | Single |
| -3db Bandwidth | 115MHz |
| On-State Resistance (Max) | 20Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Current - Leakage (IS(off)) (Max) | 10nA |
| Channel Capacitance (CS(off), CD(off)) | 32pF |
| Switch Circuit | SPST - NO/NC |
| Switch Time (Ton, Toff) (Max) | 200μs, 400μs |
| Charge Injection | 19pC |
| Crosstalk | -92dB @ 100kHz |
| Switching | BREAK-BEFORE-MAKE |
| Voltage - Supply, Single (V+) | 3V~5.5V |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
MAX14762ETB+T Overview
The electrical component comes in 10-WFDFN Exposed Pad packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. The multiplexer is located in Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. Operation at a temperature around -40°C~85°C TA. Total terminations are 10. Based on SPST - NO/NC switching circuits, these analog multiplexers work. A 2 circuit is present in this switch device. MAX14762 can be used to search for analog multiplexer variants. Internally, this switch multiplexer has a resistance of 20Ohm. The functions of 10 pins can be found in the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. Users shouldn't supply more than 5.5V voltage to the switch device. The digital multiplexer has a low cost Single supply. There should be 3V voltage fed to the electrical part below 3V. This multiplexer would work with 4.1mA current. A voltage of 3V~5.5V is required for this switch device, which drains from a single voltage source. There are SEPARATE OUTPUT outputs on this analog switch ic.
MAX14762ETB+T Features
Switch Circuit: SPST - NO/NC
4.1mA Supply Current
-3db Bandwidth: 115MHz
MAX14762ETB+T Applications
There are a lot of Maxim Integrated MAX14762ETB+T Analog Switches & Multiplexers ICs applications.
- Isolation
- DSUs
- Fiber to the Home
- Signal routing between systems
- Central office
- E1 Network Equipment
- Cellular phones
- Frame Relay Equipment
- Audio signal routing
- Cable PC