HCPL-7510
| Parameters | |
|---|---|
| Factory Lead Time | 17 Weeks |
| Mount | Through Hole |
| Mounting Type | Through Hole |
| Package / Case | 8-DIP (0.300, 7.62mm) |
| Number of Pins | 8 |
| Operating Temperature | -40°C~85°C |
| Packaging | Tube |
| Published | 2005 |
| JESD-609 Code | e0 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 2.54mm |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Base Part Number | HCPL-7510 |
| Qualification Status | Not Qualified |
| Supply Voltage-Max (Vsup) | 5.5V |
| Supply Voltage-Min (Vsup) | 4.5V |
| Number of Circuits | 1 |
| Analog IC - Other Type | ANALOG CIRCUIT |
| Operating Supply Current | 11.7mA |
| Amplifier Type | Isolation |
| Current - Input Bias | 600nA |
| Voltage - Supply, Single/Dual (±) | 4.5V~5.5V |
| Output Current per Channel | 16mA |
| Input Offset Voltage (Vos) | 600μV |
| Bandwidth | 100 kHz |
| Voltage - Input Offset | 600μV |
| Isolation Voltage | 3.75kV |
| Height Seated (Max) | 4.7mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
HCPL-7510 Overview
There is a 8-DIP (0.300, 7.62mm) case in which the instrumentation amplifier is packaged. Isolation-type instrumentation amplifiers are used in this application. A Tube case is used to deliver the buffer op amp. There have been a total of 8 terminations over the past year. This linear amplifier should be powered by an 5V battery. In total, the buffer amplifier consists of 8 pins. The input offset voltage is 600μV. It is recommended that this electronic component be mounted using the Through Hole mounting type. In terms of operating temperatures, this buffer amplifier works very well at a temperature of around -40°C~85°C . It is possible to operate this buffer amplifier from a supply current of 11.7mA . On this instrumentation amplifier, there are 1 circuits that are connected together. An analog IC known as ANALOG CIRCUIT is also used in this linear amplifier.
HCPL-7510 Features
supply voltage of 5V
HCPL-7510 Applications
There are a lot of Broadcom Limited HCPL-7510 Instrumentational OP Amps applications.
- Vehicle electronics
- ECG equipment
- Blood pressure sensors
- Power transmission
- Proportional counter tubes
- PDA
- Portable docking station
- High/low-pass filter circuit
- Car stereo
- Portable electronic products powered by batteries