FSUSB11L10X
| Parameters | |
|---|---|
| Factory Lead Time | 6 Weeks |
| Lifecycle Status | ACTIVE (Last Updated: 1 week ago) |
| Mount | Surface Mount |
| Number of Pins | 10 |
| Weight | 22mg |
| Packaging | Tape & Reel (TR) |
| Published | 2008 |
| JESD-609 Code | e4 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 10 |
| ECCN Code | EAR99 |
| Resistance | 1.15Ohm |
| Terminal Finish | Nickel/Gold (Ni/Au) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | QUAD |
| Number of Functions | 2 |
| Supply Voltage | 2.7V |
| Terminal Pitch | 0.5mm |
| Number of Outputs | 4 |
| Operating Supply Voltage | 5V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 2 |
| Voltage | 4.5V |
| Max Supply Voltage | 4.3V |
| Min Supply Voltage | 3V |
| Nominal Supply Current | 100nA |
| Current | 400mA |
| Throw Configuration | SPDT |
| Turn On Delay Time | 50 ns |
| Data Rate | 12 Mbps |
| Supply Type | Single |
| Turn-Off Delay Time | 20 ns |
| Off-state Isolation-Nom | 70 dB |
| On-state Resistance Match-Nom | 0.06Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 60ns |
| Height | 500μm |
| Length | 2.1mm |
| Width | 1.6mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
FSUSB11L10X Overview
A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). The total number of terminations is 10. High-quality output is provided by the electronic component's 2 channels. Turning on and running the electrical part should be easy with a 2.7V voltage supply. It has an internal resistance of 1.15Ohm. The functions of 10 pins can be found in the datasheets. It is a typical Multiplexer or Switches analog multiplexer. An abnormal situation would be for the switch device to be supplied with a voltage greater than 4.3V. A analog switch ic that has a cost-effective Single supply type. The lowest voltage fed to the electronic component should be 3V. The electrical part can be operated at 5V voltage levels. Temperatures higher than 85°C are not recommended for operation of the analogue multiplexer. This digital multiplexer has 4 outputs.
FSUSB11L10X Features
2 Channels
FSUSB11L10X Applications
There are a lot of ON Semiconductor FSUSB11L10X Analog Switches & Multiplexers ICs applications.
- Video signal routing
- CSU
- SONET
- Switching Systems
- Access Concentrators
- Audio and video switching
- Existing multiplexer applications (both fault-protected and nonfault-protected)
- Communication systems
- HDTV
- Automotive applications