EPM9560ARI208-10
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | QFP |
| Number of Pins | 208 |
| Published | 1994 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 |
| Number of Terminations | 208 |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| HTS Code | 8542.39.00.01 |
| Subcategory | Programmable Logic Devices |
| Technology | CMOS |
| Terminal Position | QUAD |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 220 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.5mm |
| Frequency | 144.9MHz |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Pin Count | 208 |
| Operating Supply Voltage | 5V |
| Temperature Grade | INDUSTRIAL |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 4.5V |
| Operating Supply Current | 174mA |
| Number of I/O | 153 |
| Nominal Supply Current | 174mA |
| Memory Type | EEPROM |
| Propagation Delay | 10 ns |
| Frequency (Max) | 144.9MHz |
| Programmable Logic Type | EE PLD |
| Number of Gates | 12000 |
| Number of Programmable I/O | 153 |
| Number of Logic Blocks (LABs) | 35 |
| Speed Grade | 10 |
| Output Function | MACROCELL |
| Number of Macro Cells | 560 |
| JTAG BST | YES |
| In-System Programmable | YES |
| Height Seated (Max) | 4.1mm |
| Length | 28mm |
| Width | 28mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
EPM9560ARI208-10 Overview
A mobile phone network consists of 560macro cells, which are radio coverage cells served by a high-power cell site (tower, antenna or mast).It is contained in package [0].There are 153 I/Os on the board.The device is programmed with 208 terminations.As the terminal position of this electrical part is [0], it serves as an important access point for passengers and freight.The device is powered by a voltage of 5V volts.It belongs to the family [0].With 208pins programmed, the chip is ready to use.As a building block for digital circuits, there are 12000gates.A high level of efficiency can be achieved by maintaining the supply voltage at [0].It is recommended to store data in [0].Surface Mountis the mounting point of this electronic part.There are 208pins on it.It operates at a maximum supply voltage of 5.5V volts.Normally, it operates with a voltage of 4.5VV as its minimum supply voltage.Currently, there are 153 Programmable I/Os available.There is a maximum frequency of 144.9MHz.In order to operate, the temperature should be higher than -40°C.It is recommended to keep the operating temperature below 85°C.35logic blocks (LABs) make up this circuit.There should be a lower maximum frequency than 144.9MHz.There is a type of programmable logic called EE PLD.
EPM9560ARI208-10 Features
QFP package
153 I/Os
208 pin count
208 pins
35 logic blocks (LABs)
EPM9560ARI208-10 Applications
There are a lot of Altera EPM9560ARI208-10 CPLDs applications.
- Interface bridging
- I2C BUS INTERFACE
- Custom shift registers
- TIMERS/COUNTERS
- I/O PORTS (MCU MODULE)
- Dedicated input registers
- Digital designs
- D/T registers and latches
- Cross-Matrix Switch
- State machine control