DM74ALS273N
| Parameters | |
|---|---|
| Mount | Through Hole |
| Mounting Type | Through Hole |
| Package / Case | 20-DIP (0.300, 7.62mm) |
| Number of Pins | 20 |
| Weight | 2.26g |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tube |
| Series | 74ALS |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Termination | Through Hole |
| Type | D-Type |
| Voltage - Supply | 4.5V~5.5V |
| Base Part Number | 74ALS273 |
| Function | Master Reset |
| Output Type | Non-Inverted |
| Operating Supply Voltage | 5V |
| Number of Elements | 1 |
| Polarity | Non-Inverting |
| Number of Circuits | 8 |
| Output Current | 24mA |
| Clock Frequency | 35MHz |
| Propagation Delay | 15 ns |
| Turn On Delay Time | 2 ns |
| Logic Function | D-Type, Flip-Flop |
| Current - Quiescent (Iq) | 20mA |
| Current - Output High, Low | 2.6mA 24mA |
| Max Propagation Delay @ V, Max CL | 15ns @ 5V, 50pF |
| Trigger Type | Positive Edge |
| Clock Edge Trigger Type | Positive Edge |
| REACH SVHC | No SVHC |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
DM74ALS273N Overview
In the form of 20-DIP (0.300, 7.62mm), it has been packaged. You can find it in the Tubepackage. The output it is configured with uses Non-Inverted. The trigger it is configured with uses Positive Edge. This electronic part is mounted in the way of Through Hole. With a supply voltage of 4.5V~5.5V volts, it operates. It is operating at 0°C~70°C TA. D-Typedescribes this flip flop. JK flip flop is a part of the 74ALSseries of FPGAs. This D flip flop should not have a frequency greater than 35MHz. The element count is 1 . Despite external influences, it consumes 20mAof quiescent current. The 74ALS273family includes it. It is mounted by the way of Through Hole. This board has 20 pins. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. Using 8 circuits, it is highly flexible. Optimal efficiency requires a supply voltage of 5V. In addition to its maximum design flexibility, the output current of the T flip flop is 24mA.
DM74ALS273N Features
Tube package
74ALS series
20 pins
DM74ALS273N Applications
There are a lot of ON Semiconductor DM74ALS273N Flip Flops applications.
- Frequency Divider circuits
- Safety Clamp
- Modulo – n – counter
- Single Down Count-Control Line
- Bus hold
- Single Up Count-Control Line
- ESD performance
- Load Control
- Differential Individual
- Balanced Propagation Delays