CD74HC299M96G4
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | SOIC |
| Number of Pins | 20 |
| Weight | 500.709277mg |
| JESD-609 Code | e4 |
| Pbfree Code | no |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 20 |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Max Operating Temperature | 125°C |
| Min Operating Temperature | -55°C |
| Additional Feature | COMMON I/O PINS; GATED OUTPUT CONTROL |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 4.5V |
| Pin Count | 20 |
| Operating Supply Voltage | 5V |
| Temperature Grade | MILITARY |
| Number of Circuits | 1 |
| Max Supply Voltage | 6V |
| Min Supply Voltage | 2V |
| Number of Bits | 8 |
| Propagation Delay | 34 ns |
| Turn On Delay Time | 300 ns |
| Family | HC/UH |
| Logic Function | Shift Register |
| Direction | Bidirectional |
| Output Characteristics | 3-STATE |
| Output Polarity | TRUE |
| Logic IC Type | PARALLEL IN PARALLEL OUT |
| Trigger Type | POSITIVE EDGE |
| High Level Output Current | 7.8mA |
| Low Level Output Current | 7.8mA |
| Number of Input Lines | 10 |
| fmax-Min | 23 MHz |
| Max Frequency@Nom-Sup | 23000000Hz |
| Height | 2.35mm |
| Length | 12.8mm |
| Width | 7.52mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
CD74HC299M96G4 Overview
SOIC package contains the device. A total of 20 terminations can be found on the chip. Voltage rating of the part is 4.5V. It is equipped with a pin count of 20. Using Surface Mount as a mount point is recommended. Electronic components fall under the category of HC/UH. A range of 5V is noted as the operating supply voltage of this chip. There are also the following additional considerations in this section: COMMON I/O PINS; GATED OUTPUT CONTROL. This device has 10 input lines available. There are 8 bits on the IC chip. It has a total of zero pins. A temperature below 125°C is recommended for its use. Ideally, it should not fall below -55°C. A voltage of 6V is used to supply this voltage. Voltages higher than 2V are used for this supply. In this device, there are 1 circuits that are active at the same time.
CD74HC299M96G4 Features
With 20 pins
Operate supply voltage at 5V
CD74HC299M96G4 Applications
There are a lot of Texas Instruments CD74HC299M96G4 Shift Registers applications.
- Remote control holding register
- Serial-to-parallel data conversion
- ROM Chips
- 7-segment display control
- Serial-to-parallel data conversion
- Pulse Extenders
- Data Processors
- Parallel data
- Pseudo Random Pattern Generator
- Data Format Converters