BUK139-50DL,118
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | TO-252-3, DPak (2 Leads + Tab), SC-63 |
| Surface Mount | YES |
| Operating Temperature | 150°C TJ |
| Packaging | Tape & Reel (TR) |
| Published | 2001 |
| Series | TOPFET™ |
| JESD-609 Code | e3 |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 2 |
| ECCN Code | EAR99 |
| Terminal Finish | TIN |
| Terminal Position | SINGLE |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 13V |
| Terminal Pitch | 2.3mm |
| Reach Compliance Code | unknown |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Base Part Number | BUK1 |
| Pin Count | 3 |
| JESD-30 Code | R-PSSO-G2 |
| Number of Outputs | 1 |
| Qualification Status | Not Qualified |
| Output Type | N-Channel |
| Interface | On/Off |
| Current - Output (Max) | 16A |
| Output Configuration | Low Side |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Input Type | Non-Inverting |
| Switch Type | General Purpose |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 50V Max |
| Fault Protection | Current Limiting (Fixed), Over Temperature, Over Voltage |
| Turn On Time | 30 μs |
| Rds On (Typ) | 36m Ω |
| Built-in Protections | TRANSIENT; OVER CURRENT; OVER VOLTAGE; THERMAL |
| Output Current Flow Direction | SINK |
| Height Seated (Max) | 2.38mm |
| Length | 6.6mm |
| RoHS Status | ROHS3 Compliant |
BUK139-50DL,118 Overview
As you can see, it's packaged in the way of a Tape & Reel (TR).There is a package for it in the TO-252-3, DPak (2 Leads + Tab), SC-63 package.The mounting type of the LED driver is Surface Mount.The switch type of this switch is General Purpose.Ensure reliable operation by setting the temperature to 150°C TJ.In this LED driver, there are no outputs available.A voltage of Not Required is used to power it.Voltage output is N-Channel volts at maximum.It belongs to the family BUK1.It consists of 2 terminations in total.It contains 1 functions.In this case, the LED driving board can produce only 16AV as its maximum output.The supply voltage can be 13V for high efficiency.The LED driving board is equipped with a total of 3 pins.There is an electrical component included in the TOPFET? series.
BUK139-50DL,118 Features
Supplied from 13V
BUK139-50DL,118 Applications
There are a lot of NXP USA Inc. BUK139-50DL,118 Power Switches ICs applications.
- Handheld Devices
- USB Power Distribution
- Hard Disk Drives
- Storage Drives
- Storage (HDDs, SSDs)
- Portable GPS Device
- Hot-Swap Systems
- PC Cards
- Telecom and Network Systems
- Set-top-box