BTS500251TADATMA2
| Parameters | |
|---|---|
| Factory Lead Time | 18 Weeks |
| Mounting Type | Surface Mount |
| Package / Case | TO-263-7, D2Pak (6 Leads + Tab), TO-263CB |
| Surface Mount | YES |
| Operating Temperature | -40°C~150°C TJ |
| Packaging | Tape & Reel (TR) |
| Series | Automotive, AEC-Q100, Reversave™ |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| Terminal Position | SINGLE |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 13.5V |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| JESD-30 Code | R-PSSO-G6 |
| Number of Outputs | 1 |
| Output Type | N-Channel |
| Supply Voltage-Min (Vsup) | 8V |
| Interface | On/Off |
| Current - Output (Max) | 25A |
| Output Configuration | High Side |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Input Type | Non-Inverting |
| Switch Type | General Purpose |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 8V~18V |
| Fault Protection | Over Temperature, Over Voltage, Reverse Battery, Short Circuit |
| Turn On Time | 550 µs |
| Output Peak Current Limit-Nom | 25A |
| Rds On (Typ) | 3.9m Ω |
| Turn Off Time | 550 µs |
| Built-in Protections | TRANSIENT; OVER CURRENT; OVER VOLTAGE; THERMAL; UNDER VOLTAGE |
| Output Current Flow Direction | SINK |
| Height Seated (Max) | 4.5mm |
| Width | 9.25mm |
| RoHS Status | ROHS3 Compliant |
BTS500251TADATMA2 Overview
It is packaged in the manner of a Tape & Reel (TR).There is a package for it in the TO-263-7, D2Pak (6 Leads + Tab), TO-263CB package.The LED driver is mounted as Surface Mount.General Purpose is the type of switch owned by it.To ensure reliable operation, the temperature should be set to -40°C~150°C TJ.The LED driver is equipped with 1 outputs.It uses a supply voltage of Not Required to operate.It has a maximum output voltage of N-Channel volts.There are 6 terminations in it.It consists of 1 functions.The LED driver output is limited to 25AV.High efficiency is possible when the supply voltage is set to 13.5V.This electrical component can be found in the Automotive, AEC-Q100, Reversave? series.For normal operation, the supply voltage (Vsup) should be kept above 8V.
BTS500251TADATMA2 Features
Supplied from 13.5V
BTS500251TADATMA2 Applications
There are a lot of Infineon Technologies BTS500251TADATMA2 Power Switches ICs applications.
- Gaming
- Portable GPS Device
- HDD and SSD
- Portable/Handheld Devices
- USB Power Distribution
- Solid-State Drives
- Low Voltage I/O System Power
- USB Ports/Hubs
- Wireless/Networking Cards
- Solid State Drivers