BD82007FVJ-MGE2
| Parameters | |
|---|---|
| Factory Lead Time | 10 Weeks |
| Mounting Type | Surface Mount |
| Package / Case | 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) |
| Surface Mount | YES |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Cut Tape (CT) |
| Published | 2012 |
| Series | Automotive, AEC-Q100 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| JESD-30 Code | S-PDSO-G8 |
| Number of Outputs | 1 |
| Output Type | N-Channel |
| Supply Voltage-Min (Vsup) | 2.7V |
| Interface | On/Off |
| Current - Output (Max) | 3A |
| Output Configuration | High Side |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Input Type | Non-Inverting |
| Switch Type | USB Switch |
| Nominal Input Voltage | 5.5V |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 2.7V~5.5V |
| Fault Protection | Current Limiting (Fixed), Over Temperature, UVLO |
| Turn On Time | 20000 µs |
| Output Peak Current Limit-Nom | 1.5A |
| Rds On (Typ) | 70m Ω |
| Turn Off Time | 40 µs |
| Built-in Protections | OVER CURRENT; THERMAL; UNDER VOLTAGE |
| Output Current Flow Direction | SINK |
| Length | 3mm |
| Width | 3mm |
| RoHS Status | ROHS3 Compliant |
BD82007FVJ-MGE2 Overview
As a result, it is packaged in the form of a Cut Tape (CT).It's included in the 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) package.Surface Mount is the mounting type of the LED driver.The switch type of this switch is USB Switch.It is best to set the temperature to -40°C~85°C TA to ensure reliable operation.The lighting driver has a total of 1 outputs that are available for use.The LED driving board operates at Not Required volts.A maximum output voltage of N-Channel volts has been specified.In total, there are 8 terminations.It contains 1 functions.In terms of output, the lighting driver can provide a maximum of 3A V.It is possible to achieve a high level of efficiency with a supply voltage of 5V.It is included in the Automotive, AEC-Q100 series.In order to operate normally, the supply voltage (Vsup) must remain above 2.7V.
BD82007FVJ-MGE2 Features
Supplied from 5V
BD82007FVJ-MGE2 Applications
There are a lot of ROHM Semiconductor BD82007FVJ-MGE2 Power Switches ICs applications.
- Notebook and Tablet Computers
- Set-top-box
- Portable Devices
- USB Ports/Hubs
- Hot Swap
- Telecom and Network Systems
- USB3.1 Power Delivery
- Low Voltage I/O System Power
- Handheld Devices
- Storage (HDDs, SSDs)