ADG734BRUZ
| Parameters | |
|---|---|
| Factory Lead Time | 8 Weeks |
| Lifecycle Status | PRODUCTION (Last Updated: 2 weeks ago) |
| Contact Plating | Tin |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 20-TSSOP (0.173, 4.40mm Width) |
| Number of Pins | 20 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| JESD-609 Code | e3 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 20 |
| ECCN Code | EAR99 |
| Resistance | 4.5Ohm |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 5μW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 4 |
| Supply Voltage | 2.5V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Base Part Number | ADG734 |
| Pin Count | 20 |
| Number of Outputs | 8 |
| Polarity | Non-Inverting |
| Power Supplies | 3/5/+-3V |
| Number of Channels | 4 |
| Interface | Parallel |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.8V |
| Test Frequency | 1MHz |
| Operating Supply Current | 1nA |
| Nominal Supply Current | 1μA |
| Power Dissipation | 5μW |
| Max Supply Current | 1μA |
| Turn On Delay Time | 34 ns |
| Voltage - Supply, Single/Dual (±) | 1.8V~5.5V ±2.5V |
| Supply Type | Dual, Single |
| Bandwidth | 160MHz |
| Neg Supply Voltage-Nom (Vsup) | -2.5V |
| Turn-Off Delay Time | 12 ns |
| Max Dual Supply Voltage | 2.5V |
| -3db Bandwidth | 200MHz |
| On-State Resistance (Max) | 4.5Ohm |
| Min Dual Supply Voltage | 2.25V |
| High Level Output Current | 30mA |
| Dual Supply Voltage | 2.5V |
| Multiplexer/Demultiplexer Circuit | 2:1 |
| Off-state Isolation-Nom | 72 dB |
| Current - Leakage (IS(off)) (Max) | 100pA |
| Channel Capacitance (CS(off), CD(off)) | 11pF |
| On-state Resistance Match-Nom | 0.1Ohm |
| Switch Circuit | SPDT |
| Switch Time (Ton, Toff) (Max) | 21ns, 10ns (Typ) |
| Charge Injection | 5pC |
| Crosstalk | -67dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 35ns |
| Switch-off Time-Max | 16ns |
| Max Junction Temperature (Tj) | 150°C |
| Drain to Source Resistance | 4.5Ohm |
| Height | 1.2mm |
| Length | 6.5mm |
| Width | 4.4mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Contains Lead |
ADG734BRUZ Overview
Presented in 20-TSSOP (0.173, 4.40mm Width), this electrical component is convenient for overseas shipping. In order to provide high reliability, an advanced packaging method Tube is used. There is an analog multiplexer mounted in position Surface Mount. Multiplexers and demultiplexers have a number of circuits 2:1. Temperatures around -40°C~85°C TA are extended for operation. A total of 20 terminations have been recorded. Due to its 4 channels, the electrical component produces high-quality output. Powered by a 2.5V voltage supply, the electrical part should be switched on and run. The electronic part body is injected with 20 pins. Based on SPDT switching circuits, these analog multiplexers work. Try searching with ADG734 if you're looking for variants. There is 4.5Ohm internal resistance in this digital multiplexer. You can find the functions of the 20 pins in the datasheets. The analogue multiplexer in this example is a typical Multiplexer or Switches. Multiplexers should not be powered above 5.5V in normal situations. Analogue multiplexers of the Dual, Single supply type that are cost-effective. The lowest voltage the electronic part should receive is 1.8V. This digital switch can be operated with a current of 1nA. If put voltage greater than 1μA on the device, damage may be caused to the analogue multiplexer. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 2.5V. For dual power supplies, a voltage of at least 2.25V should be attached. There are 160MHz bandwidths for data transfer. Drain to Source resistance is 4.5Ohm. The analogue multiplexer has 8 outputs.
ADG734BRUZ Features
4 Channels
Switch Circuit: SPDT
1nA Supply Current
-3db Bandwidth: 200MHz
Bandwidth: 160MHz
Drain-to-Source resistance: 4.5Ohm
ADG734BRUZ Applications
There are a lot of Analog Devices Inc. ADG734BRUZ Analog Switches & Multiplexers ICs applications.
- Cross Connects
- Digital cross connects (DSX-1)
- High-Voltage
- Frame Relay Equipment
- Audio and video switching
- Power routing
- Sample-and-hold systems
- SONET/SDH ADM
- Routers
- Avionics test equipment