74LVC1G66GM,132
| Parameters | |
|---|---|
| Factory Lead Time | 13 Weeks |
| Contact Plating | Tin |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 6-XFDFN |
| Number of Pins | 6 |
| Operating Temperature | -40°C~125°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2001 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| Resistance | 15Ohm |
| Max Power Dissipation | 250mW |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 2.7V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | 74LVC1G66 |
| Pin Count | 6 |
| Operating Supply Voltage | 5V |
| Polarity | Non-Inverting |
| Number of Circuits | 1 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.65V |
| Operating Supply Current | 200μA |
| Number of Ports | 2 |
| Nominal Supply Current | 100nA |
| Max Supply Current | 200μA |
| Number of Bits | 1 |
| Throw Configuration | SPST |
| Turn On Delay Time | 5.3 ns |
| Family | LVC/LCX/Z |
| Output Characteristics | 3-STATE |
| Supply Type | Single |
| Turn-Off Delay Time | 4.2 ns |
| Logic IC Type | BUS DRIVER |
| -3db Bandwidth | 500MHz |
| On-State Resistance (Max) | 10Ohm |
| High Level Output Current | 50mA |
| Low Level Output Current | 50mA |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Current - Leakage (IS(off)) (Max) | 5μA |
| Channel Capacitance (CS(off), CD(off)) | 6.5pF |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 4.2ns, 5ns |
| Charge Injection | 7.5pC |
| Voltage - Supply, Single (V+) | 1.65V~5.5V |
| Height Seated (Max) | 0.5mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
74LVC1G66GM,132 Overview
The electrical component comes in 6-XFDFN packaging, which makes it convenient to ship overseas. High reliability is achieved by using advanced packaging method Tape & Reel (TR). Mounted in Surface Mount is this multiplexer. 1:1 is the ratio between multiplexers and demultiplexers. The operating temperature is extended to around -40°C~125°C TA. Totally, there are 6 terminations. When the electronic component is given a voltage of 2.7V, it should be turned on and run. An electrical component like this is included in the 6 series. Multiplexers built on a SPST - NO switching circuit are built. Circuits number 1 make up this analogue multiplexer. Try searching for the analog switch ic with 74LVC1G66 if you are looking for variants. An switch multiplexer with 15Ohm internal resistance has a value of 15Ohm. The datasheets for the 6 pins explain the functions. Multiplexers should not be powered above 5.5V in normal situations. Digital switch that provides Single power at a cost-effective price. The lowest voltage the electronic part should receive is 1.65V. For this multiplexer to operate, 200μA current would be sufficient. This analog switch requires a voltage of 1.65V~5.5V to drain from a single voltage supply. A voltage higher than 200μA may cause damage to the switch multiplexer. The electrical part can be operated at 5V voltage levels. It conducts in a 1-bit manner.
74LVC1G66GM,132 Features
Switch Circuit: SPST - NO
200μA Supply Current
-3db Bandwidth: 500MHz
1-Bit
74LVC1G66GM,132 Applications
There are a lot of Nexperia USA Inc. 74LVC1G66GM,132 Analog Switches & Multiplexers ICs applications.
- Avionics and Military Systems
- High-Voltage
- Fiber to the Home
- Relay Replacement
- Precision data acquisition
- Sample hold systems
- Industrial control systems
- MP3 players
- Remote wireless modules
- Data switching