74AC574PC
| Parameters | |
|---|---|
| Mounting Type | Through Hole |
| Package / Case | 20-DIP (0.300, 7.62mm) |
| Surface Mount | NO |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Series | 74AC |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 20 |
| Type | D-Type |
| Terminal Finish | MATTE TIN |
| Additional Feature | BROADSIDE VERSION OF 374 |
| Technology | CMOS |
| Voltage - Supply | 2V~6V |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | NOT APPLICABLE |
| Supply Voltage | 3.3V |
| Terminal Pitch | 2.54mm |
| Reach Compliance Code | unknown |
| Time@Peak Reflow Temperature-Max (s) | NOT APPLICABLE |
| JESD-30 Code | R-PDIP-T20 |
| Function | Standard |
| Qualification Status | Not Qualified |
| Output Type | Tri-State, Non-Inverted |
| Number of Elements | 1 |
| Supply Voltage-Max (Vsup) | 6V |
| Supply Voltage-Min (Vsup) | 2V |
| Number of Ports | 2 |
| Clock Frequency | 153MHz |
| Family | AC |
| Current - Quiescent (Iq) | 40μA |
| Output Characteristics | 3-STATE |
| Current - Output High, Low | 24mA 24mA |
| Output Polarity | TRUE |
| Number of Bits per Element | 8 |
| Max Propagation Delay @ V, Max CL | 9.5ns @ 5V, 50pF |
| Trigger Type | Positive Edge |
| Input Capacitance | 4.5pF |
| Length | 26.075mm |
| Width | 7.62mm |
| RoHS Status | ROHS3 Compliant |
74AC574PC Overview
The package is in the form of 20-DIP (0.300, 7.62mm). It is contained within the Tubepackage. Tri-State, Non-Invertedis the output configured for it. The trigger configured with it uses Positive Edge. The electronic part is mounted in the way of Through Hole. Powered by a 2V~6Vvolt supply, it operates as follows. It is operating at -40°C~85°C TA. It belongs to the type D-Typeof flip flops. JK flip flop belongs to the 74ACseries of FPGAs. It should not exceed 153MHzin its output frequency. A total of 1elements are present in it. It consumes 40μA of quiescent current without being affected by external factors. Terminations are 20. The power source is powered by 3.3V. A JK flip flop with a 4.5pFfarad input capacitance is used here. It is a member of the ACfamily of D flip flop. As soon as 6Vis reached, Vsup reaches its maximum value. Normally, the supply voltage (Vsup) should be kept above 2V. There are 2 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. In addition, BROADSIDE VERSION OF 374is a characteristic of it.
74AC574PC Features
Tube package
74AC series
74AC574PC Applications
There are a lot of Rochester Electronics, LLC 74AC574PC Flip Flops applications.
- Storage Registers
- Latch-up performance
- Control circuits
- Automotive
- Set-reset capability
- Latch
- ESD protection
- Shift registers
- Storage registers
- Data transfer