7208L20J8
| Parameters | |
|---|---|
| Factory Lead Time | 7 Weeks |
| Contact Plating | Lead, Tin |
| Mount | Surface Mount |
| Package / Case | PLCC |
| Number of Pins | 32 |
| Published | 2009 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 32 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Additional Feature | RETRANSMIT |
| Subcategory | FIFOs |
| Technology | CMOS |
| Terminal Position | QUAD |
| Terminal Form | J BEND |
| Peak Reflow Temperature (Cel) | 225 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 1.27mm |
| Pin Count | 32 |
| Operating Supply Voltage | 5V |
| Power Supplies | 5V |
| Temperature Grade | COMMERCIAL |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 4.5V |
| Element Configuration | Dual |
| Nominal Supply Current | 120mA |
| Max Supply Current | 120mA |
| Clock Frequency | 33.3MHz |
| Access Time | 20 ns |
| Organization | 64KX9 |
| Density | 576 kb |
| Standby Current-Max | 0.008A |
| Parallel/Serial | PARALLEL |
| Sync/Async | Asynchronous |
| Word Size | 9b |
| Memory IC Type | OTHER FIFO |
| Bus Directional | Unidirectional |
| Retransmit Capability | Yes |
| FWFT Support | No |
| Output Enable | NO |
| Cycle Time | 30 ns |
| Height Seated (Max) | 3.556mm |
| Length | 13.97mm |
| Width | 11.43mm |
| Thickness | 2.79mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
7208L20J8 Overview
PLCC is a package that contains FIFO memory chip.Mounting it in Surface Mount is recommended.When the supply voltage is 5V there is the possibility of high efficiency.A total of 32 terminations can be found in FIFO means.32 pins are the operation pins.Its maximum operating current is 120mA .For FIFO's maximum efficiency, the supply voltage should be set to 5V .This FIFO products runs at 0°C degrees Celsius at a minimum temperature to ensure reliability.Keeping the operating temperature at 70°C °C allows the FIFO products to operate continuously.It is self-contained in FIFOs .A OTHER FIFO type memory IC is present in the FIFO memory chip.Low supply voltages, such as 4.5V V, may be required for operation.A maximum voltage of 5.5V volts can be applied to FIFO memory.There are a total of 32 pins on this board.Normally, 5V power supplies are owned by the component.This gadget can also be used to generate RETRANSMIT .This FIFO memory IC has a clock frequency of 33.3MHz .
7208L20J8 Features
FIFOs category
Clock frequency of 33.3MHz
7208L20J8 Applications
There are a lot of Integrated Device Technology (IDT) 7208L20J8 FIFOs Memory applications.
- SPI Bus Flash Memory Devices
- Event Recorder
- IP Radio
- Address mapping
- Multimedia
- Game Controller
- Measurement Equipment
- Disk Controllers
- Queues for communication systems
- Laser Receiver System