MAX4641EUA
| Parameters | |
|---|---|
| Contact Plating | Tin |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) |
| Number of Pins | 8 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 2002 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Resistance | 4Ohm |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 362mW |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 2 |
| Supply Voltage | 3V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Base Part Number | MAX4641 |
| Pin Count | 8 |
| Polarity | Non-Inverting |
| Power Supplies | 3/5V |
| Number of Channels | 2 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.8V |
| Operating Supply Current | 1μA |
| Nominal Supply Current | 1nA |
| Max Supply Current | 1nA |
| Throw Configuration | SPST |
| Turn On Delay Time | 15 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 8 ns |
| On-State Resistance (Max) | 4Ohm |
| High Level Output Current | 50mA |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 80 dB |
| Current - Leakage (IS(off)) (Max) | 250pA |
| Channel Capacitance (CS(off), CD(off)) | 7pF 7pF |
| On-state Resistance Match-Nom | 0.2Ohm |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 15ns, 8ns |
| Charge Injection | 2pC |
| Channel-to-Channel Matching (ΔRon) | 200m Ω |
| Crosstalk | -97dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Switch-off Time-Max | 10ns |
| Voltage - Supply, Single (V+) | 1.8V~5.5V |
| Drain to Source Resistance | 4Ohm |
| Normal Position | NC |
| Height | 950μm |
| Length | 3.1mm |
| Width | 3.1mm |
| Radiation Hardening | No |
| REACH SVHC | Unknown |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
MAX4641EUA Overview
As the electronic part is packed in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width), international shipping is convenient. This high-reliability packaging method uses advanced packaging methods Tube. It is mounted in the position Surface Mount. Multiplexers and demultiplexers have the same number of circuits 1:1. Operation at a temperature around -40°C~85°C TA. Total terminations are 8. Due to its 2 channels, the electrical component produces high-quality output. A 3V voltage supply should turn on and run the electronic component. Electronic part bodies are injected with 8 pins. The analog switch ics are built using SPST - NO switching circuits. Try searching with MAX4641 to find analog multiplexer variants. In this multiplexer, the internal resistance is 4Ohm. Please refer to the datasheets for 8 pins functions. This switch device is a typical Multiplexer or Switches. A voltage higher than 5.5V should not normally be supplied to the switches. The analog switch ic is of the Single supply type and is cost-effective. 1.8V is the lowest voltage the electrical component should receive. This digital switch can be operated with a current of 1μA. This analog switch requires a voltage of 1.8V~5.5V to drain from a single voltage supply. Put voltage above 1nA on the multiplexer to cause damage. There is 4Ohm resistance between Drain and Source for this electronic part.
MAX4641EUA Features
2 Channels
Switch Circuit: SPST - NO
1μA Supply Current
Drain-to-Source resistance: 4Ohm
MAX4641EUA Applications
There are a lot of Maxim Integrated MAX4641EUA Analog Switches & Multiplexers ICs applications.
- Microwave transmission systems
- Cable PC
- Fiber to the Home
- Imaging
- Medical Instrumentation
- Audio and video routing
- Avionics and Military Systems
- Automotive applications
- Residential Gateways, Home Gateway/Router
- Routers