74LVC1G66GS,132
| Parameters | |
|---|---|
| Factory Lead Time | 13 Weeks |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 6-XFDFN |
| Number of Pins | 6 |
| Operating Temperature | -40°C~125°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2009 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| Resistance | 15Ohm |
| Terminal Finish | Tin (Sn) |
| Max Power Dissipation | 250mW |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | NO LEAD |
| Number of Functions | 1 |
| Supply Voltage | 3.3V |
| Terminal Pitch | 0.35mm |
| Base Part Number | 74LVC1G66 |
| Polarity | Non-Inverting |
| Number of Circuits | 1 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.65V |
| Operating Supply Current | 200μA |
| Number of Ports | 2 |
| Number of Bits | 1 |
| Throw Configuration | SPST |
| Propagation Delay | 3 ns |
| Family | LVC/LCX/Z |
| Supply Type | Single |
| Logic IC Type | BUS DRIVER |
| -3db Bandwidth | 500MHz |
| On-State Resistance (Max) | 10Ohm |
| High Level Output Current | 50mA |
| Low Level Output Current | 50mA |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Current - Leakage (IS(off)) (Max) | 5μA |
| Channel Capacitance (CS(off), CD(off)) | 6.5pF |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 4.2ns, 5ns |
| Charge Injection | 7.5pC |
| Voltage - Supply, Single (V+) | 1.65V~5.5V |
| Height Seated (Max) | 0.35mm |
| RoHS Status | ROHS3 Compliant |
74LVC1G66GS,132 Overview
Due to its 6-XFDFN packaging, the electronic part is convenient for international shipping. This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). Surface Mount is where this multiplexer is located. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. Increasing operating temperature to around -40°C~125°C TA. Total terminations are 6. With a 3.3V voltage supply, the electrical component should be turned on and run. These analog multiplexers are built based on SPST - NO switching circuits. A total of 1 circuits make up this switch device. Try searching with 74LVC1G66 to find analog multiplexer variants. This digital multiplexer has 15Ohm internal resistance. You can find the functions of the 6 pins in the datasheets. It is generally not recommended to supply a voltage higher than 5.5V to the switch device in normal circumstances. Digital switch that provides Single power at a cost-effective price. 1.65V is the lowest voltage the electrical component should receive. It would be sufficient to run this analogue multiplexer with 200μA current. This analogue multiplexer requires a voltage of 1.65V~5.5V when it drains from a single voltage supply. 1-bit operation is possible.
74LVC1G66GS,132 Features
Switch Circuit: SPST - NO
200μA Supply Current
-3db Bandwidth: 500MHz
1-Bit
74LVC1G66GS,132 Applications
There are a lot of Nexperia USA Inc. 74LVC1G66GS,132 Analog Switches & Multiplexers ICs applications.
- Central office
- DSUs
- CSU
- Fiber In The Loop (FITL)
- Cellular phones
- Data Acquisition Systems
- ISDN NT1/TA
- Automotive applications
- Cable Modem
- USB 1.1 signal switching circuits